|
Aquamist
2S water injection system - Installation
complete. All I had to do was connect the
water injection jet to the manifold. All the
wiring was complete. While the wiring looks
daunting, I was able to finish it in a few
hours. I wanted to mount as close as possible
to the injector nozzle so as to minimize the
line distance and reduce pressure losses.
|
|
Click to enlarge |
| |
|
|
Here
is the tangle of wire that have to be hooked-up
for the MF2 ECU to create a 3D water injection
map. With the help of
Brad from KC Saab and the manual,
the installation went fairly smoothly. I did
have some problems getting a clean RPM signal
from the DI cassette, so I eventaully tapped
into the back of the ECU.
|
|
Click to enlarge |
| |
|
|
| |
|
|
| |
|
|
| This
is a pic of the custom mounting bracket I
made to hold all the components. As you can
see, the pump is installed in the underside.
|
|
Click to enlarge |
| |
|
|
| This
is a picture of the bracket from another angle. |
|
Click to enlarge |
| |
|
|
| This
is a close-up of the injector nozzle on the
intake manifold. I installed it before the
temp sensor. |
|
Click to enlarge |
| |
|
|
